That is to say, any heat you put down into the slab eventually finds its way back up into the room. ![]() If you go with anything, you’re looking at something that will reflect the radiant heat.ġ) An insulating layer does not change the overall efficiency of the system. Greg, There are differing opinions on the insulating layer. Be careful walking with shoes on across the wire, as a stone or other object caught in the treads could nick the wire. After you finish the install, carefully recheck all the wire to ensure it is tightly bonded to the floor.Move down the wire hot gluing the wire every 12-18″ or wherever the wire protrudes from the flat plain of the surface of the slab.(Note that in some places you may have to cut the radiant heating wire out of the mesh, as shown in the picture above). The hot glue will begin to freeze quickly, creating a tight grasp around the wire. If your slab is below-grade, it is probably 50-60 degrees. Drop a pool of hot glue onto the slab under where the wire will go.Hobby models that use 1/8″ sticks will go through glue sticks too quickly). Plug in and heat up an electric glue gun. You’ll want to use a “professional glue gun” that can take 1/2″ glue sticks.(All radiant heating flooring vendors will provide you a plan for how to lay out the radiant wire if you first give them a drawing of the room). Lay out the mat according to your plan for the room.Steps for Hot Gluing Radiant Heated Flooring Mats Hot gluing the mats allows thinset or SLM used to cover the mats to be poured at a mere 1/8″ – 1/4″ thick. Most radiant heating wires are approximately 1/16″ – 3/32″ thick. Gluing down the wires ensures they don’t move. Crossed wires create an unsafe condition and will likely cause the mats to overheat when they are operated. For instance, all electric radiant heating systems require that the heating wires never cross. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |